Tech/maintenance Sticky Neck

Plastic Scourer. No metal removed. It leaves no marks, just cleans all the crap off.
I use Scotchbrite pads to put a finish on a variety of metals after turning them on the lathe.
If you take a plain old plastic scourer and rub it against a piece of tarnished brass it'll go right through the tarnish and start bringing up a shine. It's an abrasive.

In the context of using one on a crook joint it's probably going to be fine....every once in a blue moon though. I'd consider it a last resort. When I need to clean the joint after all other methods have failed I'd use XXXX steel wool - followed by a thorough cleaning and degreasing. It's much finer and more controllable.
 
Every time you buff or polish a brass part, a minute amount of material is removed. This is not necessarily a bad thing if it is not done to excess. I regularly "clean" the neck tenon of a saxophone before returning it to the customer using a strip of 1500 grit micro mesh from JL Smith. I hold the neck using a petal neck expander in a vice, and "rag" a few strokes in each direction. The final step is to clean the tenon using a bit of brass valve oil on a paper towel and double check the air tightness with a neck leak checker.
 
0000 steel wool is great for polishing. Including car windows with heavy water stains. Just clean well after use. Residual material dust rusts very quickly!
I use white automotive polishing compound often.
1670872274457.webp

5E09D23E-BE89-472C-91D0-8A1688E8F405.png

Polishing brass article
 
Last edited:

Similar threads... or are they? Maybe not but they could be worth reading anyway 😀

Social

New! Social Feeds

Look out for the navigation icon:

Follow CafeSaxophone

Latest Song of the Month

Trending

Forum statistics

Topics
32,075
Messages
578,663
Members
8,134
Latest member
banjo
Back
Top Bottom