picconose
Member
- Messages
- 73
- Location
- Westminster, MD
Several thoughts on sticking pads, in no particular order:
1. Whenever I put my sax in the case, I place a business card under the G# pad. (I tear them in half to fit under the pad of my soprano).
2. Talc, cornstarch, or any other powder, even if cleaned off, tends to leave just a tiny bit behind in the ring, where the pad seats. As soon as it gets wet, it turns to goop, and does me dirty. I don't use it. That goes for so-called "chalk papers" as well.
3. On the gig or in a rehearsal, I always carry a new-ish bill for the emergency pad wipe. If we take a break, I place the business cards referred to in item 1, above, under the pads while I am off the stand.
4. I was recently taking with my instrument repairman about this problem. He says sticking is usually caused by humidity getting into the pores of the pad, and there really isn't too much that can be done about it. I asked him about using WD-40, since it is designed to displace water. He said it can be used by spraying a bit on a cotton swab, and lightly brushing the sealing surface of the pad, but be sure not to get any on the tone hole. He thought it might attack lacquer, and also might add to sticking problems if on both surfaces. He reiterated that the horn should be stored with a card stock under the pad.
5. Here's a hint that is slightly off-topic, but I'll toss it out while I am thinking of it. I do a lot of theater pit orchestra work, and often have to go for a long period playing on one instrument while the reeds on the others are drying out. Then I have to grab one with very little time between instruments. To keep the reed from drying out, I cut small pieces of cellulose sponge, and after wetting them, place them against the reed, under the reed cap. When I snatch the reed cap off, the sponge stays inside the cap, and the reed is moist and playable.
1. Whenever I put my sax in the case, I place a business card under the G# pad. (I tear them in half to fit under the pad of my soprano).
2. Talc, cornstarch, or any other powder, even if cleaned off, tends to leave just a tiny bit behind in the ring, where the pad seats. As soon as it gets wet, it turns to goop, and does me dirty. I don't use it. That goes for so-called "chalk papers" as well.
3. On the gig or in a rehearsal, I always carry a new-ish bill for the emergency pad wipe. If we take a break, I place the business cards referred to in item 1, above, under the pads while I am off the stand.
4. I was recently taking with my instrument repairman about this problem. He says sticking is usually caused by humidity getting into the pores of the pad, and there really isn't too much that can be done about it. I asked him about using WD-40, since it is designed to displace water. He said it can be used by spraying a bit on a cotton swab, and lightly brushing the sealing surface of the pad, but be sure not to get any on the tone hole. He thought it might attack lacquer, and also might add to sticking problems if on both surfaces. He reiterated that the horn should be stored with a card stock under the pad.
5. Here's a hint that is slightly off-topic, but I'll toss it out while I am thinking of it. I do a lot of theater pit orchestra work, and often have to go for a long period playing on one instrument while the reeds on the others are drying out. Then I have to grab one with very little time between instruments. To keep the reed from drying out, I cut small pieces of cellulose sponge, and after wetting them, place them against the reed, under the reed cap. When I snatch the reed cap off, the sponge stays inside the cap, and the reed is moist and playable.
