Tutorials
Shop
Youtube
|
Bluesky
|
acebook
Supporting special needs music education since 2008
About
Café fundraising
📣 Advertise
Mailing
Pete Thomas music
Biog
?
Rules, terms, privacy
Forum help (guide)
Tech support forum
Discussion
All forum sections
Start a discussion
Reviews (feed)
Articles
Articles on the Cafe
Articles on Taming The Saxophone
Shop
NEW
Log in
Register
What's new
All forum sections
Start a discussion
Reviews (feed)
Menu
Log in
Register
How to install the app
How to install the app on iOS
NB: For Safari start at step 2
(Firefox only) Tap on the hamburger menu at bottom right
Tap on the share icon
(bottom of page)
Scroll down and tap on
Add to Home Screen:
Note:
This feature may not be available in some browsers.
Discussion
Main Discussion sections
🎷 Saxophones: gear, playing, repair, impro 🎷
Neck/Crook surgery?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="turf3" data-source="post: 476258" data-attributes="member: 8105"><p>No, you keep the distance from tip of MP to the horn (any point you choose) about the same. If the neck is 3/8" longer, it reduces that effective volume in the MP, but it does so as far away from the tone generating part of the MP as possible. Think about it. If you play your horn with your preferred mouthpiece when it's hot and you're pulled way out, then you play the same setup when it's cold and you're pushed way in, the general tonal quality really isn't affected much if at all. So from the tonal standpoint extending the neck further into the mouthpiece bore is the same thing. </p><p></p><p>I believe that the closer to the tip you modify the internals of the mouthpiece, the bigger the effect.</p><p></p><p>The Conn 6M was designed with the micro tuner with the idea that you would determine the best place on the cork for your particular mouthpiece, then screw the tuner in and out to keep that place. I did the experiment, with a tuner, and what I found was that between the tuner screwed all the way in and the MP 1/2" or more out, vs. the MP pushed all the way in and the tuner screwed out about the same distance, made only very small and subtle differences in tone and tuning. </p><p></p><p>So OP's concern about losing the tone he likes using a larger chamber piece on this particular horn, might not be a problem if the chamber volume reduction happens down where the MP pushes onto the cork. Now that said, note that I also said that variations in tuning were also minor in my 6M experiment. So the chance that OP will get the pitch of the thing to go up as much as he wants, with the same MP position, is probably not that great. But it's an easy thing to simulate - you can cut some shirt cardboard, roll it up in the end of the MP, shove it on and see - or you could temporarily glue some thick sheet cork to the end of the neck. Then shove the MP on to the same distance from tip of MP to [registration point] and see what happens. Easy, fast, fully reversible. </p><p></p><p>The key dimension for an accurate scale is the distance from the tip of the MP to [registration point of your choice on the horn; I generally use the octave vent]. </p><p></p><p>This is why when people chopped 1/2" off all those Louis Lot flutes in the 1930s that were built to A = 435, and pushed in, to supposedly play them at A=440, all the high notes got sharp and the low notes got flat; and then an entire two generations of flute pedagogy were developed based on people playing A = 435 flutes at A = 440 with a scale too long for the pitch.</p><p></p><p>Whole point is that some experimentation is going to be required. If your experimental results make the problem WORSE, then you've learned that doing the opposite has a good chance of making it BETTER. I also suspect that in the end, some compromises will have to be made, and OP will have to accept some degree of sharp upper register in order to play the horn "in tune" (compromise). </p><p></p><p>Might be worth getting a grab bag of cheap necks (from various models), getting them roughly fitted to the horn, and seeing what intonation effect each one has.</p></blockquote><p></p>
[QUOTE="turf3, post: 476258, member: 8105"] No, you keep the distance from tip of MP to the horn (any point you choose) about the same. If the neck is 3/8" longer, it reduces that effective volume in the MP, but it does so as far away from the tone generating part of the MP as possible. Think about it. If you play your horn with your preferred mouthpiece when it's hot and you're pulled way out, then you play the same setup when it's cold and you're pushed way in, the general tonal quality really isn't affected much if at all. So from the tonal standpoint extending the neck further into the mouthpiece bore is the same thing. I believe that the closer to the tip you modify the internals of the mouthpiece, the bigger the effect. The Conn 6M was designed with the micro tuner with the idea that you would determine the best place on the cork for your particular mouthpiece, then screw the tuner in and out to keep that place. I did the experiment, with a tuner, and what I found was that between the tuner screwed all the way in and the MP 1/2" or more out, vs. the MP pushed all the way in and the tuner screwed out about the same distance, made only very small and subtle differences in tone and tuning. So OP's concern about losing the tone he likes using a larger chamber piece on this particular horn, might not be a problem if the chamber volume reduction happens down where the MP pushes onto the cork. Now that said, note that I also said that variations in tuning were also minor in my 6M experiment. So the chance that OP will get the pitch of the thing to go up as much as he wants, with the same MP position, is probably not that great. But it's an easy thing to simulate - you can cut some shirt cardboard, roll it up in the end of the MP, shove it on and see - or you could temporarily glue some thick sheet cork to the end of the neck. Then shove the MP on to the same distance from tip of MP to [registration point] and see what happens. Easy, fast, fully reversible. The key dimension for an accurate scale is the distance from the tip of the MP to [registration point of your choice on the horn; I generally use the octave vent]. This is why when people chopped 1/2" off all those Louis Lot flutes in the 1930s that were built to A = 435, and pushed in, to supposedly play them at A=440, all the high notes got sharp and the low notes got flat; and then an entire two generations of flute pedagogy were developed based on people playing A = 435 flutes at A = 440 with a scale too long for the pitch. Whole point is that some experimentation is going to be required. If your experimental results make the problem WORSE, then you've learned that doing the opposite has a good chance of making it BETTER. I also suspect that in the end, some compromises will have to be made, and OP will have to accept some degree of sharp upper register in order to play the horn "in tune" (compromise). Might be worth getting a grab bag of cheap necks (from various models), getting them roughly fitted to the horn, and seeing what intonation effect each one has. [/QUOTE]
Insert quotes…
Verification
Post reply
Join us in the Cafe!
Social
New! Social Feeds
Look out for the navigation icon:
Follow CafeSaxophone
Foroverse
Youtube
Bluesky
Facebook
Latest Song of the Month
SOTM
November 26 SOTM - Footprints - Wayne Shorter
Started by sax panther
Nov 1, 2026
Replies: 11
Cafe Members' Recordings & Gigs
T
SOTM
SOTM October 2026 - The Chicken
Started by Taragot
Sep 30, 2026
Replies: 18
Cafe Members' Recordings & Gigs
SOTM
SotM September 2026 - Autumn Leaves
Started by mrblackbat
Sep 1, 2026
Replies: 27
Cafe Members' Recordings & Gigs
SOTM
SOTM August 2026 - Creep
Started by atwl77
Jul 31, 2026
Replies: 13
Cafe Members' Recordings & Gigs
SOTM
and Play by ear July 2026
Started by Wade Cornell
Jun 30, 2026
Replies: 21
Cafe Members' Recordings & Gigs
SOTM
SOTM June 2026 "And You Just Smile" (from ear to ear- training)
Started by LostCircuits
May 30, 2026
Replies: 11
Cafe Members' Recordings & Gigs
SOTM
SOTM May 2026 - Always Remember Us This Way
Started by MikeMorrell
Apr 28, 2026
Replies: 39
Cafe Members' Recordings & Gigs
SOTM
SOTM April 2026 - Freedom Jazz Dance
Started by rhysonsax
Mar 31, 2026
Replies: 14
Cafe Members' Recordings & Gigs
SOTM
SOTM and PETE (Play by Ear Training Exercise)
Started by Wade Cornell
Feb 28, 2026
Replies: 16
Cafe Members' Recordings & Gigs
SOTM
SOTM Feb 2026 - On Green Dolphin Street
Started by mrblackbat
Jan 31, 2026
Replies: 44
Cafe Members' Recordings & Gigs
SOTM
SOTM January 2026: Our Love Is Here to Stay
Started by GCinCT
Jan 1, 2026
Replies: 46
Cafe Members' Recordings & Gigs
SOTM
SOTM December 2025: Wexford Carol
Started by MikeMorrell
Nov 30, 2025
Replies: 37
Cafe Members' Recordings & Gigs
Member Blogs (currently active)
Saxophones
Pork Tales: Saxophone Repair DIY Adventures.
Started by PigSquealer
May 22, 2025
Replies: 1K
🎷 Saxophones: gear, playing, repair, impro 🎷
Blog
Tenor Viol's musings
Started by Tenor Viol
Oct 22, 2016
Replies: 2K
☕️ Breakfastroom (chat and relax...) ☕️
Blog
Mike's musings
Started by MikeMorrell
Sep 5, 2024
Replies: 296
☕️ Breakfastroom (chat and relax...) ☕️
Trending
Pork Tales: Saxophone Repair DIY Adventures.
PigSquealer
May 22, 2025
Replies: 1K
Daily Check In
Jeanette
Apr 21, 2024
Replies: 3K
H
The Alphabet of Tone
Hassles
Nov 15, 2026
Replies: 124
Tenor Viol's musings
Tenor Viol
Oct 22, 2016
Replies: 2K
Low Bb vs low A baritones.
Pete Thomas
Oct 29, 2026
Replies: 197
S
What are you listening to (plus reviews)
suethesax
Nov 18, 2007
Replies: 3K
Do we really need theory?
jbtsax
Feb 18, 2016
Replies: 507
L
Alto for warm tone
LisaP2026
Nov 14, 2026
Replies: 76
The Cafe Trio grown to Octet down to Sextet
trimmy
Feb 15, 2015
Replies: 846
Learn to play by ear or by reading music
Taz
Feb 16, 2016
Replies: 1K
Popular Discussions
Great Players
Who sparked your love of Sax music
Started by jools
Apr 2, 2008
Replies: 630
🎷 Saxophones: gear, playing, repair, impro 🎷
Playing the saxophone
The Cafe Trio grown to Octet down to Sextet
Started by trimmy
Feb 15, 2015
Replies: 846
🎷 Saxophones: gear, playing, repair, impro 🎷
Theory & Impro
Do we really need theory?
Started by jbtsax
Feb 18, 2016
Replies: 507
🎷 Saxophones: gear, playing, repair, impro 🎷
Saxophones
C Melody Saxophones
Started by Andy Hornblower
Aug 19, 2015
Replies: 706
🎷 Saxophones: gear, playing, repair, impro 🎷
Saxophones
Carrying a tenor on a (motor)bike?
Started by Jay
Jul 4, 2015
Replies: 741
🎷 Saxophones: gear, playing, repair, impro 🎷
Saxophones
How will Tariffs affect Sax Prices?
Started by Ivan
Apr 4, 2025
Replies: 465
🎷 Saxophones: gear, playing, repair, impro 🎷
Jazz
Music for Night Owls
Started by saxplorer
Mar 5, 2015
Replies: 466
Great music and favourite Videos
Playing the saxophone
Learn to play by ear or by reading music
Started by Taz
Feb 16, 2016
Replies: 1K
🎷 Saxophones: gear, playing, repair, impro 🎷
Tech/maintenance
My new "DIY" pads...
Started by DavidUK
Jan 12, 2022
Replies: 393
🎷 Saxophones: gear, playing, repair, impro 🎷
6
Misc Reviews
Yamaha YDS-150 Wind Synth
Started by Acc6441
Oct 22, 2020
Replies: 301
🎷 Saxophones: gear, playing, repair, impro 🎷
Forum statistics
Topics
32,079
Messages
578,707
Members
8,136
Latest member
peterdehelegrote
Discussion
Main Discussion sections
🎷 Saxophones: gear, playing, repair, impro 🎷
Neck/Crook surgery?
Back
Top
Bottom