Introduction Hello

Miranda, Hi, From your introduction, and replies to posts, leaves me in no doubt that you will do well, and are already at home with the somewhat dubious characters that frequent this site, I've only been a member a couple of months, and learnt er lots. All the best to you

Glyn
 
Many thanks to everyone for the warm welcome :thumb:

Well, I went and did it. Bought the Alto, that is. I'm getting on quite well - I can just about (well, 50% of the time), get the highest D well above the stave and have gone down to the lowest D just below the stave. I am still tending to over blow according to my tutor (having been used to clarinet) and my embouchure still needs to settle. Reaching - well, I can just reach the keys for the lowest C, but unlike the clarinet, there is no hole to cover so it is easier. I do have fairly long fingers, so that helps. Need to tune properly though - played with a CD and found myself woefully flat. Being small and wimpy, I can't push the mouthpiece on any further. I keep putting cork grease on - I suppose it will give eventually.

GAS - well, I think it has hit. I need a harness still, just bought a reed holder, need another pull through, a sax stand, music, Yamaha 4C mouthpiece..... etc! Pity Christmas is over, but have a birthday in a couple of months! 😀

Miranda

I found that jiggling and wiggling (the mouthpiece, not yourself!) helps to get the mouthpiece onto the cork further, and while you're trying to get it on that bit further I'd suggest taking the crook off the instrument, holding the crook just below the cork in your left hand with the cork facing towards you, then holding the mouthpiece in your right fist; then push / juggle and wiggle the mouthpiece onto the cork, with your hands in that "one potato, two potato" position. If you take the crook off the instrument, you can't accidentally bend or distort anything. Once you've got the mouthpiece on and off a few times, it will all become so much easier.

As for the harness, check that you can get one short enough, or get one that you can un-stitch and re-sew if necessary - I had a NeoTech and made it shorter as I couldn't get the sax high enough to reach my mouth before the two sides of the harness came together and started to choke me! I now have a made-to-measure Cebulla for my alto. Even though I'm 5ft6, I don't understand why the harnesses are always too long for me (I'm just an odd shape, I guess)

Welcome to the Cafe, BTW. You'll enjoy the company.
Mandy (originally from the Fens of North Cambridgeshire!)
 
Thank you John and Glyn! It seems a very friendly place, and people have a great sense of humour.

Mandy - I treated myself to a soft Neotech sax harness in regular. My mum (bless her) has altered it for me to fit!! The sliders at the back were as short as they could go, and the front slider for the sax height was at its shortest! It's great now. I didn't know whether the child one would be uncomfortable around the ..... erm, womanly parts!

I will try what you say with the mouthpiece. It is getting a little easier - I keep smearing Dr Slick all over it.

miss-saxophone - not short - just not very tall. Emphasis on the tall, hopefully you forget the "not very"!! 😀 In fact, I suppose if you measured me, I am probably the same height as Araceli. I just have delusions of grandeur saying I'm nearly 5ft....it sounds much better! haha🙂))
 
miss-saxophone - not short - just not very tall. Emphasis on the tall, hopefully you forget the "not very"!! 😀 In fact, I suppose if you measured me, I am probably the same height as Araceli. I just have delusions of grandeur saying I'm nearly 5ft....it sounds much better! haha🙂))

Well, to be fair, nearly everyone compared to myself are short! But yes, that's shortest, so I'll treat you as tall. 🙂
 

Social

New! Social Feeds

Look out for the navigation icon:

Follow CafeSaxophone

Latest Song of the Month

Trending

Forum statistics

Topics
32,076
Messages
578,679
Members
8,134
Latest member
banjo
Back
Top Bottom